Visit the DOWNLOADS page to access all the downloads needed for the latest updates.
Motion Controller Board Firmware
Latest Version: 0.0.66
Preserve ideaMaker Custom Profiles
ideaMaker 3.3.0 offers new settings for Pro2 preset printing profiles. For users who would like to keep a copy of their original profiles, or custom created profiles, follow the instructions provided by the video below.
* N-Series profiles will not be affected by this update and will automatically transfer. For N-Series users ideaMaker can be installed normally.
Latest Version: 3.3.0
Follow the "RaiseTouch Firmware Update" video steps (0:00 - 1:10) below to begin the installation of RaiseTouch 1.1.0.
After restarting , version 1.1.0 will display a prompt on the screen. Accept the EULA (end user license agreement) to continue.
After completion, a secondary prompt will appear. Accept this to apply the latest acceleration and jerk settings.
Restart your machine one final time to confirm all settings have been applied.
Latest Version: 1.1.0